I am creating an application that uses standard function that sets bitrate. The parameters required are BTR0 and BTR1. But the user of my application will enter the standard value of the Baudrate (eg. : Bitrate = 125000). How can i calculate BTR0 and BTR1 from the given value?
Baudrate and BTR0/BTR1
baudratebit ratecan
Related Topic
- Electronic – the maximum bitrate supported in the Can Bus
- Electronic – STM32L0 Low power UART-receiver reads the wrong data at high baudrate after MCU waking up
- Electronic – Cutoff frequency on a CAN bus communication line
- Electronic – Why is the CAN bus always busy (microcontroller)
- Electronic – Does a baudrate in serial communication (USB or RS232) need to be exact
- Electrical – USART baudrate in STM32L152
- Electrical – Transmission distance rs485 vs ethernet
Best Answer
The CanCase parameters are compatible to the SJA1000. Chapter 6.5 of its datasheet should answer your question.