Bias tee with very small low cut-off frequency

biasRF

I need to measure the noise spectrum of a diode under certain bias.
The noise frequency I am interested is in the range of several Hz to tens or hundreds of kHz. I am thinking of using a bias tee with fairly small low cut-off frequency. But the low cut-off frequencies of bias tees I am looking at are still a little high (for example, in http://www.picosecond.com/product/category.asp?pd_id=2 the minimum low cut-off frequency is 3.5kHz). I am also thinking of DIY such a bias tee. For example, the post I need to design a Bias-T circuit for a diode laser – help choosing component values discussed how to design a bias tee working around 10MHz with 25kHz bandwidth. However, in my situation, I at least need it to go from hundred Hz to tens of kHz.

My questions is : 1) is there a commercial product available somewhere else that fits my needs? 2) If there is no such commercial product, how to DIY?

Thanks.

Best Answer

A single capacitor is all you need. The term for this is a "DC blocking capacitor". You commonly see them in audio circuits but they are used elsewhere.

The value of the capacitor is dependent on the input impedance of whatever you are feeding after the blocking cap. The lower the input impedance, the higher the value of cap that is required. Also, the lower the frequency response you need, the higher the value of cap.

A cap of only 10 uF is good if the input impedance is fairly high (100's of K ohms). But if the impedance is lower then you might need 68 uF or even 100 uF.

Unfortunately there is often some amount of trial and error needed when selecting the proper capacitor value-- especially if you do not accurately know the input impedance.