I am new to electronics, so please bear with nonsense questions, if any.
I want to make a Solar Mobile phone charger. I found various ways in internet to do that. I am confused between using TP4056 module and LM2596 module.
I have two solar panels – a 6V 100mA panel and a 9V 200mA panel
I have to make a 5V 1A DC output to charge my mobile phone through USB.
Allow me to describe the advantages (what I understand) of using either module.
TP4056 – This module is basically used to charge Li-ion batteries with 3.7V DC. But it has also a 5V DC output tertminal. From the datasheet of TP4056, I found that typical input supply current is 150 microA. But the output of my solar panels are much larger.
LM2596 – This is a switching mode regulator. It efficiency is higher. I can set the output voltage to 5V (from a wide range of 4-40V) DC by adjusting a screw. Here is the datasheet of LM2596.
Now, I want to know the following things.
- Which solar panel should I use?
- Which module is better to make the charger – TP4056 or LM2596?
Thanks in advance.
Best Answer
First of all, you will not be able to generate a 5V 1A output with any of these modules, simply because your solar panels aren't strong enough. Even if we assume you use the (stronger) 9V 200mA one and step the voltage down to 5V with 100% efficiency (which isn't possible), you would only get 9/5*200mA = 360mA at 5V. The real vlaue will be even lower.
But in general, what you want is a simple step-down converter, either with fixed 5V output or adjustable output set to 5V. The TP4056 is not the right module, because it's designed to charge the LiIon battery by itself, but the phone has the charging circuit already built-in. The LM2596 would therefore be the better choice.
But if you continue with the project, I strongly suggest that you use a better solar panel, because at less than 360mA, your phone will charge either very slowly or not at all.