Electronic – Run IAR Program without Debugging

iarstm32

I'm having a simple problem with IAR Embedded Workbench, programming an STM32 using an ST-LINK/V2 programmer. I'm trying to run a program that temporarily switches off the JTAG pins, so I can't run it all the way through in debug mode. What I would like to do is load and run the program (without debugging), then connect the debugger to the running program to check a few values and make sure it actually ran.

I can't figure out how to do either of these steps with IAR. I've tried doing a "Download active application" followed by a "Debug without Downloading," but either the program didn't start running or when the debugger connected it reset the program. When I try to use the "Attach to Running Target" option, I get an error message saying "The debugging session could not be started."

Any ideas on how to do this?

Best Answer

Old topic, no answer. For anyone who comes here, the solution is explained by IAR at THIS link.

Related Topic