Electronic – the common name for this seal-in relay

hysteresislevelrelayswitcheswater

I'm trying to build a hysteresis water pump system with 2 water level switches. Please see the diagram and explanation of this setup I've taken off the web:

Diagram of hysteresis water pump system

The first switch (L) is set at the minimum liquid level desired in the tank. The second switch (H) goes at the maximum desired level. When the liquid is below both switches, they are both closed; the pump runs, filling the tank. As the liquid fills past the first switch, it opens. However, seal-in relay A has been activated and closed, bypassing the now-open switch L (effectively “sealing it in”), so the pump continues to run until the high-level switch H opens. When the high-level switch opens, the motor relay P opens, stopping the motor, and seal-in relay A opens.

My question is, what is a seal-in relay in the consumer market?

I can buy water level switches on ebay for like 5 bucks, but I am finding it hard to find what a seal-in Relay switch is that is needed for this schematic. And i'm looking at something very basic and cheap to be just enough to do the task. My problem is I can't buy this item because searching for seal-in relay gets me no where.

Thanks!

Best Answer

A "seal in" contact is just another normally open contact on a relay.

The name "seal in" comes from the application of the contact. Most electronics people aren't likely to have heard of the terminology of "seal in". The term is used in industrial controls (which now days use relays and PLC).

Choose a relay that is suitable for your needs.

Edit 1 : Obtain a relay that has 2 contacts. Use your level switch to turn on the relay. Use one of the relay normally open contacts to drive your pump motor. Use the relay's 2nd normally open contact as your "seal in" contact, which is then wired across your level switch.

So, use your level switches to drive relays which can handle higher current than your level switches. Then the relay contacts are used where you would normally place your switches.

EDIT 2 : To search for a relay, use the words "control relay". A control relay contact can be called a "seal in" or any other name you desire.

schematic

simulate this circuit – Schematic created using CircuitLab

Here is a circuit that should work for you.

You can use 12 volts or 24 volts. Just get relay with coil voltage to match what you want to use.

Related Topic