Electronic – What does it mean when it says ‘0’ after a resistor value, for example 1k00 or 11k0
resistorsschematics
What does it mean when it says '0' after a resistor value, for example 1k00 or 11k0? Two examples are R7 and R8 in the schematic posted below:
What are the extra zeros?
Best Answer
It is (better, it is supposed to be if schematic's author has done a good job) an good indication of resistor tollerance.
If I write 1k00 i.e. 1.00 kΩ I mean resistor should be between 995 Ω and 1004.999 Ω hence it must be a ±0.5% or better.
Likewise if I had written 1k0 I'd have asked for a 950 Ω to 1049.999 Ω resitor i.e. ±5% or better one.
Basically one should not write meaningless digits, those shown in the number must be there because their are true.
So writing 1k00 5% is inconsistent and should be avoided while 1k 0.1% is ok for plain writing tolerance overrides missing digits.
NO POPmeansnot populated (i.e. the space on the PCB is there, but there's no component). In this case you'd install nothing.
Zero-ohm resistors are used just for jumpers (so the same machinery can be used for jumpers and actual resistors). In this case you could use a jumper or a wire.
It means you use 2 x 22 uF for the output i.e. two 22 uF caps in parallel and for the input you use 2 x 10 uF caps in parallel. It's not commonly used but I have seen it dozens of times at least.
Best Answer
It is (better, it is supposed to be if schematic's author has done a good job) an good indication of resistor tollerance.
If I write 1k00 i.e. 1.00 kΩ I mean resistor should be between 995 Ω and 1004.999 Ω hence it must be a ±0.5% or better.
Likewise if I had written 1k0 I'd have asked for a 950 Ω to 1049.999 Ω resitor i.e. ±5% or better one.
Basically one should not write meaningless digits, those shown in the number must be there because their are true.
So writing 1k00 5% is inconsistent and should be avoided while 1k 0.1% is ok for plain writing tolerance overrides missing digits.
Of course the same applies to any quantity.