As far I've understood, channel formation takes place because of the induced negative charge on the semiconductor side of the gate capacitance. So shouldn't the charge concentration increase linearly with the gate voltage from the very beginning. If that is so the current should increase linearly as gate potential is increased from zero. Instead why does the current increase abruptly from zero when a threshold voltage is hit. Why is the sudden increase in carrier concentration?
Electronic – Why does the MOSFET drain current increase abruptly when Gate voltage is greater than the threshold voltage
mosfetsemiconductorssolid-state-devicestransistors
Related Topic
- Why does drain current stop increasing after a certain value of gate voltage is obtained by a MOSFET
- Electronic – Does MOSFET switching gate drive current depend on supply voltage
- Electrical – Why the current across a diode is zero when the forward bias voltage is less than barrier potential
- Electronic – In MOSFETs why is the gate-body inversion layer voltage able to create a conducting channel, yet the same source-drain voltage not
- Electrical – How to minimize the effect of threshold voltage mismatch of a current mirror
- Electronic – Diffusion current causes drift current
Best Answer
It doesn't. It is (very near) zero below threshold, but it only starts increasing gradually from zero as it goes above threshold. Here's a "typical" characteristic for a low-voltage MOSFET:
It's not the carrier concentration that changes at threshold. It's the availability of the channel.
Below threshold, the channel is "pinched off" so that no current can flow, even though there are charge carriers available.
Imagine you use your fingers to pinch a drinking straw closed. If you slowly release the pressure of your fingers, you see no current flow until you get to some "threshold" pressure and water starts flowing. It's not because the amount of available water changed, it's because you allowed a path to open so that the water that was there all along could flow. The channel of the MOSFET behaves similar to that.