The following image shows my connections:
The grounds of all devices are connected to a common PCB. When I measure the 1.2V referenced to the ground on my PCB, it reads 1.201V which is great. But when referenced to the common GND PCB, it increases by 23mV, I expected it to be lower than 1.201V (because of bigger ground loop, therefore more voltage drop) not higher, how come?!
Edit #1 : Notes
- I have only ONE voltmeter used for both measurements, sorry it's not clear in the image.
- "My PCB" is supplied by 64V from the shown power supply, then it's converted to 12V then to 1.2V
Edit #2 : More Notes
-
These measurements are the same even before I soldered the rest of the board. I solder power modules first of all, even before a load exists I got these results!
-
The "common PCB" is a one layer board that is only used as a common ground. It has no ICs or passive components. Only copper pour and holes for crocodiles to be attached.
Best Answer
Because there is current flowing thru the ground wire between your PCB and the common ground point. The wire has a small resistance. The current time this resistance causes a offset voltage. For example, if there were 1 A flowing in the wire, then it would only need to have 23 mΩ resistance to exhibit the 23 mV offset.
Another more subtle possibility is that you have high frequencies in the system that are confusing the meter electronics. Above some frequency, probably somewhere in the 10s of kHz to 100s of kHz range, some meters without adequate filtering may start seeing AC as DC. Old purely mechanical meters are pretty much immune to this, but modern meters with active electronic front ends provide various ways for high frequency AC to be treated non-symmetrically and therefore to add a offset to the DC measurement. That all said, this is rather less likely than the much simpler explanation of a offset voltage accross the ground wire due its resistance times current thru it.