Linux – Need help setting up an HP Procurve 2650 switch via serial using Linux.

hphp-procurvelinuxserialswitch

I recently bought an HP Procurve 2650 (J4899A) off ebay and it came out without a serial cable. So I also purchased a null modem serial cable (rs232) to connect to it (Assuming this is the right one). I have plugged it into a box running debian and have been struggling to connect to it. I have tried to connect to it with Minicom and Putty with no luck.

The switch itself starts up no problem, I just seem to be having the issue with connecting to it. In putty I have set all the serial settings correctly with reference to the switches manual (ftp://ftp.hp.com/pub/networking/software/j489990001.pdf) but I seem to have hit a brick wall. Even though there is no option to set putty's terminal elimination to VT100 I assume it sets/detects it automatically.

Just to note I can not connect to the switch via Telnet or the web interface as it has been reset back to factory settings.

I have hit a brick wall as I do not know what to try next. Do I have the wrong serial cable?

Has anyone one else encountered this same issue?

Best Answer

A null-modem cable should work... But in this case, just reset the device to its factory settings.

To execute the factory default reset on the switch, perform these steps:

  1. Simultaneously press the Reset and Clear buttons on the front of the switch with a paperclip.
  2. Continue to hold the Clear button while releasing the Reset button.
  3. When the Self Test LED begins to blink, release the Clear button.

The switch will then complete its self test and begin operating with its configuration restored to the factory default settings.

The switch should also obtain a DHCP address if you have a DHCP server on the network.

Related Topic