Category: electrical
- Is discontinuous conduction mode of a buck converter more efficient than continuous conduction mode
- Steer multiple LEDs with one microcontroller pin
- Does the SPI protocol specify how many clock pulses a master device should send to the slave
- LTSpice change output voltage of gate
- Using a 2 A, 48 VDC rated switch in a 8 A, 12 VDC circuit
- Is it ok to set the unused I/O pins of the ATmega8A to input and connect all of them to ground
- Control LEDs with 74HC595 shift register through SPI
- Powering a micro-controller using the SCT-013-000
- Why does STM32CubeIDE debugger always stop on HAL_Init()
- LM2907 – Too many iterations without convergence – Proteus