8051 micro controller on chip ROM address range? MEMORY SIZE

For greater detail on anything STM32F4 related you should refer to the STM32F4 Reference Manaul - it tells you everything you could ever need to know about anything.

For instance, in section 3, it tells you:

So you can see than bank 1 is 0x08000000 to 0x080FFFFF and bank 2 is 0x08100000 to 0x081FFFFF.

You can't tell for sure just by looking at the size of the memory. Often the processor will have an addressing range that exceeds the amount of memory the computer is designed to take. Most processors have at least a 64k address range, so a computer with only 1k or 16k of memory is probably limited by other factors.

At the other end of the scale, having a large amount of memory does not mean that the processor must have equally large address registers. For example the Intel 8086 achieved a 1 Megabyte address range by adding two 16 bit registers together. Another way to increase addressing range is to use an I/O port to set the upper address lines, thus switching different bits of memory in one bank at a time (this is commonly used with 8 bit CPUs to access more than 64k of memory).

The size of data and instruction registers may match the data bus width, but there are many exceptions. 16 and 32 bit processors often have 8 bit registers that can be used independently or concatenated to make 16 or 32 bits. Some are able to access single bytes on a 16 or 32 bit data bus. It is also possible to have internal registers that are wider than the buses. For example the Motorola MC68008 executes 16 bit instructions and has 32 bit data and address registers, but only has an 8 bit data bus and a 20 bit address bus.