I have an LVDS differential 100OHM signal which I want to convert to a single-ended 50 OHM signal. I want to use a BALUN for this conversion.
What kind of BALUN should I use here?
Some BALUNs have 1:1 conversion ratio.
Some have 2:1 impedance conversion ratio.
Thanks
Best Answer
A 100 ohm diff signal is essentially 2 x 50 ohm single ended signals (I know that's a very same analogy).
In the past ive connected one end of the differential signal to the receiver with a 50R series resistor, and the other end terminate with 100R to GND.