I would like to do a bit of prototyping and have been wanting to leverage edge connectors as it would make my layout a whole lot easier. When using these, are you forced to get some kind of prototyping board that has built in fingers like this:
Do they sell stand-alone, through-hole fingers that can be added to a pre-existing prototyping board? Maybe the connector and plug as a bundle? I'm looking for something very specific… ~60pin, through-hole, ideally wire-wrap.
On a side note, if anyone knows where to even get the boards with built-in edge connectors that would be great too. I can't really find any but that's probably because I don't know the proper search terms.
Best Answer
Probably no. You may want to roll your own board for this.