Electrical – Is There an Alternative to Resistor based Voltage Divider for an DC Audio Signal with Less Noise

If you draw 1mA from the resistor divider circuit you mentioned, it will output one volt (the upper resistor will have 1.1mA flowing through it, thus dropping 11 volts; of that 1.1mA, 0.1mA will go through the bottom resistor while the remaining 1mA will go into your load). The 6K resistor would drop 6 volts, thus feeding 6 volts into a 100mA load.

If either the load current or the load resistance is a known constant value, one can calculate a series resistance which will convert a known input voltage into any desired known, lower, load voltage. If the load current or resistance isn't known precisely, however, deviations from the ideal will cause the load voltage to vary from what is intended. The greater the difference between the input voltage and the load voltage, the greater the variation in load voltage.

Adding a load resistor will effectively add a known fixed load in addition to the potentially-variable one. Suppose one had a 12-volt source and the intended load were 10uA +/- 5uA at 6 volts. If one just used a series resistor sized for the 10uA case (600K), it would drop only 3V at 5uA (feeding 9 volts to the load) and 9V at 15uA (feeding 3 volts to the load). Adding a 6.06K resistor in parallel with the load would cause the total current draw to be about 1.000mA+/-0.005mA, requiring the upper resistor be changed to 6K; since changes in the load current would only affect the total current by about 0.5%, they would only affect the voltage drop of the upper resistor by about 0.5%.

If the source voltage is stable, and the output current is small, a voltage divider may be a practical means of generating a stable voltage. Unfortunately, for the voltage divider to generate a stable voltage, the amount of current fed through the lower resistor (and thus wasted) must be large relative to the possible absolute variation in load current. This is usually no problem when the output current is on the order of picoamps, is sometimes acceptable when the output current is on the order of microamps, and generally becomes unacceptable when the output current is on the order of amps.

Yesterday I was experimenting with Rigol ds1052e myself and yes you WILL see 50Hz noise with probe without even touching anything. Try to connect ground alligator to the tip of the probe and you will pick up even more noise. This goes away when you unplug probe from BNC. So yes, this is from the probe itself, not necessarily from your circuit. I've seen people suggesting to use coiled piece of wire around ground barrel on the probe, rather than attaching ground alligator. See this link for details http://e2e.ti.com/support/power_management/simple_switcher/w/simple_switcher_wiki/2243.understanding-measuring-and-reducing-output-voltage-ripple.aspx

Also check if your scope has bandpass filter. It might help.