I installed header pins that fit into a feather microcontroller, but since they are not double sided header pins, the top side is too short to attach normal jumper wires to. Is there some clean, non-permanent solution to this where I can still attach jumper wires, but not solder or desolder any existing pins?
Electrical – Jumper wire solution for short header pins /
breadboardheaderjumperprototyping
Related Topic
- Electronic – Female headers for breadboard (or: how to extend the pins of the breakout board?)
- Electrical – Best way to solder connections between header posts
- Electronic – How to make connection on pcb (circuit board) holes without solder (for prototyping)
- Electrical – jumper wires better for VCC or ground
- Electrical – inverted PCB plug approach (to connect two single sided boards with jumpers)
- Electronic – Intercept pin headers, three way or the header
Best Answer
Either cut the plastic and lift it off the pins, or use test clips or micro grabber clips to attach to the remaining headers. You could also use wire wrap. Or solder a second header to that header. It's possible just ugly.
Or save the hassle and just desolder and resolder a new one of the right length. It will take you less time than hacking something.