Electrical – Second order active low pass filter values

filter

I want to use a second order active low pass filter to cut off frequencies over 33kHz . The input is 1.3 Volts peak to peak sine wave of 32 Khz and I want to make it 30kHz of 1Vpp . The formulas for calculating the values on the components of S.O.A.L.P. are for different SOALP than mine . Can someone provide me with the formulas that I need to calculate the values of my schematic or better provide the values and explain

Edit: the op amp is provided 20V in the [+] wire and is grounded on the [-] wire

Edit 2: the formulas I found for other SOALP are on this link
http://www.electronics-tutorials.ws/filter/second-order-filters.html

enter image description here

Best Answer

There are better steps to design a filter of this type;

Define specs then choose the type of knee response.. Low Q like Bessel give flat group delay or rate of change of phase shift. Higher Q with steeper edge like Chebychev compromise group delay but steeper edge and some ripple in passband. Others include Butterworth, etc.

Filter specs

  1. Choose Type & order (2, 4, 6, 8 ...) (low cost and much better performance)
    or choose characteristics ( better)

  2. Ensure DC bias is in valid CM range by adding biasing, e.g. Vcc/2 instead of Gnd.

  3. Scale R up and C down to minimize current
  4. Check input bias current offset voltage and balance both input R equiv with suitable R's. on (+) input.
Related Topic