I'm in a bit of a pickle here. I need to translate 3.3v to 5v ttl levels. The devices I'm driving (12 total) are not low current devices so I don't want to interface directly, even with a current limiting resistor.
This is a reference design that I plan on selling and I want it to be as fault tolerant as possible. My first pass was just to add 100Ohm resistors across each output from the microprocessor (3.3v output). I'm rethinking that however and I was looking at voltage translation. The two techniques that look most promising for me is either a pass through transistor interface using a MOSFET such as bs170 and the other is to use a dedicated chip such as the TXB0108 voltage translator.
Here is my conundrum. I really want to keep the cost of these boards down. I've sourced the mosfets at mouser for about .25$ each when buying in lots of 100. The voltage translator ic's are a bit more expensive at about 4 bucks each, when bought in large lots. My biggest issue is I only need 12 pins to be translated so it seems on the second IC I would be wasting 4 pins. The mosfets are going to cost about 3 bucks per board (way less than the IC's) with a couple of resistors it brings up to 3.10 or so. So, that cuts my BOM cost by about 6 bucks, but my issue is the space on the board. Those 12 mosfets (and accompaning resistors) take up WAY more room than the two ICs (which take no external components).
TLDR; Does anyone know of another (cheaper and less room) than the two methods I mentioned above? I need to translate 3.3v up to 5v. It will only be output since the signal is unidirectional (always 3.3v -> 5v).
Best Answer
Since you are translating from a 3.3 V source to a 5 V destination, and you specified TTL levels, you may in fact not need any translation circuit at all. TTL circuits switch at around 0.8 V, and only expect 2.0 V nominal for a high level input. So if your micro can generate 2.0 V it will be able to fully switch a standard 5 V TTL input.
If you need to provide more current than your micro can source, then you should be able to use any 5 V TTL buffer chip. For example, the octal buffer 74LS244, which findchips shows in the USD 0.60 range at qty 100.
If you really don't trust your micro to produce 2 V output when high, or if you aren't completely sure the downstream device use true TTL levels, and you don't need an exceptionally fast switching, you can use an open-drain output buffer like 74LVC07A as a translator. The chip can be powered by 3.3 V, but its output high level is controlled by an external pull-up voltage, for which you'd use 5 V. These are 6 channels per chip, and they're less than USD 0.25 each at the quantities your talking about.