Since a lock-in amplifier is effectively a high-precision AM demodulator, what are the most critical characteristics for amplifiers in the high-frequency signal chain? Take a 50kHz lock-in circuit for example where 40dB of gain is applied before performing synchronous detection by an AD630 or an ADC for digital mixing with and objective dynamic range >80dB. It is easy to find op-amps with <10nV/√Hz @ 50kHz so noise can be made negligible for a narrow output bandwidth (basically the rational for using lock-in detection). It seems to me that 1/f noise of the system may be dominated by amplifier power supply rejection, gain stability of feedback network, offset drift, etc.
Which amplifier parameters should be optimized in this case where we need to minimize introducing AM noise on a high-frequency narrow-band signal? Will some of these things (such as offset drift) be eliminated entirely by AC coupling?
Best Answer
Yes, coupling eliminates low frequency noise
You don't need to use an AD630, a circuit like this will do, then you can choose a suitable amplifier for your application with the right bandwith and noise.
Source: http://www.analog.com/en/analog-dialogue/articles/synchronous-detectors-facilitate-precision.html
Another way to do the lock in amp is like this:
simulate this circuit – Schematic created using CircuitLab
The amplifier parameters will be determined by how much SNR you need for your application. The bandwidth of the amplifier will be determined by the lock in frequency (it will need to go faster and much faster than the next cycle). Offset is usually not a problem since it shifts the DC and the ADC by a few bits.