Regarding SPDT ic relay TS5A3157. Do we have a delay responz inside the İc/ do we have a click sound. Because im startıng for a new project that can switch wireless, bluetooth or ir. What i need on my project is an actual or quick responz with no delay, if we have a delay may i know. How many milli seconds thanks in advance.
Electronic – arduino – ic relay.. is there any delay for the responz of <İC insıde the circuit
arduinorelaysensorswitches
Related Solutions
you can design the circuit using IC555 and CD4033(D-Flip Flop).By using an SPDT switch you can select option a or b.
You can use a logic-level gate MOSFET such as the IRLB8314PbF.
simulate this circuit – Schematic created using CircuitLab
The resistor R2 pulls the MOSFET gate low if the I/O goes high-Z. R1 limits the GPIO current.
This part has a maximum Rds(on) of 3.2m\$\Omega\$ with 4.5V or better drive, so at 5A it will barely get warm (80mW -> about 5°C rise) even without a heatsink. Only about $1 each in 10's. The diode D1 is to absorb the inductive energy in the motor winding when the MOSFET switches off. It is rated at 3A continuous, which is more than adequate to handle brief 5A spikes.
Best Answer
All the information you will need to use this device can be found in the datasheet, which can be downloaded from www.ti.com
This part is an analog switch, not a mechanical relay. As it is entirely solid-state, it will not click when operated.
Note that the signal being switched must remain between Ground and Vcc.