i get this error:
avrdude: stk500_getsync(): not in sync: resp=0x00
when trying to upload a example sketch.
pin (0,1) are not occupied;
it is the right serial port with latest drivers
i choosed the right board
The RX led blinks 2 or 3 times when i try to upload.
Full log:
avrdude: Version 5.11, compiled on Sep 2 2011 at 19:38:36
Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
Copyright (c) 2007-2009 Joerg Wunsch
System wide configuration file is "D:\Utz\Downloads\arduino-1.0.4\hardware/tools/avr/etc/avrdude.conf"
Using Port : \\.\COM3
Using Programmer : arduino
Overriding Baud Rate : 57600
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude done. Thank you.
Best Answer
Try hitting the RESET button just around the time
avrdude
starts. Maybe you were not entering the boot loader—the Nano is supposed to have auto-reset, but maybe that’s not working in your setup.