Electronic – Can super amplified line-level audio (e.g. 60Hz sine) signal be used as an AC power source

You need something like the 4066. Luckily, there are smaller versions with only one switch inside, like a tiny 6-pin SPDT, with 1/3 the circuitry of a 4053.

• NLAS4599: Single SPDT Analog Switch Single Supply
• NLASB3157: Single SPDT Analog Switch
• FSA4157 Low Voltage 1 Ohm SPDT Analog Switch

(I was just looking at these parts for this question.)

You can find examples of how to bias and interface with these kinds of parts here:

• Bypassing and Switching with the CD4053 CMOS Analog MUX
• Audio Switch Notes (also shows a JFET switch)
• "The Juggler 4 is a CMOS based effects order switcher"

Detecting the signal - do you want to do it the hard way or the easy way - if the signal amplitude is in the order of 3 or 4 V peak-to-peak then it can be done the easy way using a couple of signal diodes, a couple of capacitors and a resistor. This would be fed via a Schmidtt trigger into an IO line. At a push the Schmidtt may be avoided if the logic levels are 3.3V.

The hard way means that the signals levels are lower than 3 or 4 volts peak-to-peak and an input amplifier needs to be inserted to boost the signal up to these sort of levels.

There are simpler audio detectors based around a couple of transistors and these might be suitable too but, due to their simplicity they may trigger on noise or crosstalk. These might be good enough though.

There are a few ICs that can apply large amounts of gain and then large amounts of compression to boost small signals to the same amplitude as larger signals and these could play a role.

None of the circuits described above will cause any appreciable deterioration of the original analogue signal but care would need to be taken when connections are made to audio lines.

The answers are all here (above) and to move further you need to do a little work on measuring the signal levels or opt for the more sophisticated system with gain so that small-ish signals can be detected and acted upon.