Electronic – How should I connect batteries in parallel

It is very common to connect lead-acid batteries in parallel to increase capacity.

A common house battery bank on pleasure boats consists of four or more, 6 volt "golf cart" batteries connected in series/parallel to make a 12 volt battery bank. There is no need for diodes or other isolation between batteries.

Some people express concern that a shorted cell in one battery will cause overheating of the wireing, but I have had a couple of cases of a shorted cell with no problem other than being unable to fully charge the bank.

I have no experience with LiFe batteries.

This is one of those best-practices arguments that never actually gets a really good answer. There is nothing technically wrong with having that light-green jumper installed. But the problems start when you begin to consider the failure modes of the batteries.

As lead acid battery ages, its internal resistance increases as things build up on the plates, and the plates themselves begin to break down and change shape. Eventually, the plates will fail, and you will probably wind up with a shorted cell in one of those batteries. If it goes open (which is rare), all is well and you just lose the capacity in that set - but you have to consider the short as the most dangerous possibility.

When this happens, if that jumper is installed, the half of the batteries on the same side as the faulted pack are going to discharge through the dead battery with virtually no resistance. This can be an incredibly bad thing, potentially resulting in a catastrophic discharge, and possibly exploding cells.

With the jumper out, you still have the entire bank of batteries discharging itself, but it would be reduced by the internal resistance AND voltage of the other battery in the line that didn't short out. Any resistance is better than no resistance, and the voltage reduces it even further, so the battery pack you are worried about protecting is actually needed to prevent a potentially devastating current flow.

Of course, it is worth pointing out that what you have done is technically no worse than paralleling any number of single battery packs. But the internal short problem is the primary design consideration that makes almost every battery bank go in series first, and then add banks in parallel - it helps that those lead acid batteries themselves are a number of cells in series, packaged as a single unit.

So, from a best practices perspective, you really should remove that jumper. Any compromises made to protect equipment, in this case, merely endanger other equipment in a different way, and create new concerns about your safety.