The design I have in mind will be battery operated, so I have found the TL972 (Datasheet Here) which only operates from 0 – 12 V.
What I want this op-amp to do is to create a sawtooth/triangle wave generator to drive a VCO, namely the POS-535+ (Datasheet here). The frequency we want the VCO to output is around 300 – 400 MHz, and according to the figure named "Frequency and Tuning Sensitivity" in that datasheet, 2 – 7'ish volts will cover that output range of frequencies. (For the design, I want 1 – 8 V just to be on the safe side.
. . .
I have researched all over the Internet, but the only op-amps I am seeing that will generate the desired waveforms swing and operate from negative voltages. I have tried those circuits, to no avail.
Technically, I could use an LDO voltage regulator to output a negative voltage for an op-amp, but this will add more complexity/cost to the circuit and will be considered as a last resort.
So designing this circuit isn't too easy as first we have to make the first portion of the op-amp create a square wave, and then the other will create the ramp. I'm not entirely sure how to do that and would like help/pointers on doing so. Unfortunately, I have no schematics thus far for reference as all the schematics I have seen are for op-amps that operate between negative to positive.
. . .
Also, to generate a ramp wave of 1 – 8 V is pretty dang broad. If there is a better VCO that operates no more than 12 V and covers 300 – 400 MHz, please by all means recommend one to me if that is more convenient than designing a ramp wave that sweeps 1 – 8V.
Any help, guidance, or pointers is greatly appreciated!
(Forgive my terminology if I misused some terms. Engineer in progress here.)
Best Answer
You've specified your VCO output frequency range but didn't specify the triangle / sawtooth wave frequency. I'm guessing that you're using this to sweep the VCO so it will be operating at a much, much lower frequency. If that's the case then all the 300 - 400 MHz info in your question is irrelevant.
Figure 1. Square and triangle wave generation. (Don't use 741s. Use something modern.) Image source: Circuits Today.
In the case of the triangle wave you could use something like that of Figure 1 but instead of referencing R3 and R6 to battery negative you would generate a mid-supply reference and connect them to that.
simulate this circuit – Schematic created using CircuitLab
Figure 2. A mid-supply ground reference.
You'll see this solution used a lot in guitar effects pedals that run from a single 9 V battery but require AC swing about the "zero" reference internally.
Remember that op-amps don't have a GND pin. They only have a positive and negative supply so they don't care what your GND is as long as you give it adequate voltage between it's power pins and don't exceed the maximum input specifications.