Electronic – Is it alright to connect NC (no internal connection) to the ground

pcbpcb-design

I understand "NC" means you better "leave it hangin'". However, due to the brimful nature of my boards full of components, and the Kierkegaardian genius who designed this component:
http://ww1.microchip.com/downloads/en/DeviceDoc/20002200D.pdf
package

that put the GND pin squarely in the middle rather on the side of the component, I now find myself in the position of having no choice but to connect a trough-hole to GND by laying tracks right through the NC pin, since under the component laid several tiny trough-holes already.

So I'm wondering is it OK for me to do that (connect NC to GND)? Since in the datasheet it specifically said:

enter image description here

But I'm not 100% sure?

Or I could be wrong, there shouldn't be any non-GND via under the power IC, and instead, there should be a patch of GND plane?

Best Answer

This one is really clear, surprisingly clear in fact ... downright enlightened. That additional wording that MicroChip put in ... "true ..." makes it a very safe bet that you can perform whatever routing function through that pin you wish to ease your layout. The only caveat is not to put a sensitive net through the pin, since it will add parasitics (a handful of pF) if it matters.

Alternate wordings would be "DNC" for do not connect, which is a command, not a suggestion. or "Reserved" where you must fear for your life if you ever connect that pin incorrectly.

I've been reading data sheets since the '70s and they have not been better or worse across time. This one is very clear.

To convince yourself, put your meter on the highest resistance range to each pin in turn. Checking that it declares over-range. Make sure that you perform each measurement with both polarities of the meter. Most meters use a one-polarity source, often ramping in a triangle, so they read differently each way and a diode will fool you.

Related Topic