casesmounting-holespackagespcb
Apart from this edge mounting kit from Adafruit, what are some ways to mount a PCB that does not have mounting holes?
I'm looking for non-permanent mounting solutions that take up little real-estate (visual and physical). So this excludes hot glue, velcro, and zip ties.
The standoffs used for mounting glass and signs for example are a possibility but they do not come in a small form factor or cheaply…
Is there anything you can grab from a local hardware or crafts store that would do the job?
When eagle generates Gerbers, holes end up as non-plated holes. For a mounting hole, it's good when it's not plated.
Making non-plated holes requires an additional step in the fabrication process. Some PCB fabs do non-plated holes as a part of their standard service. Some automatically convert non-plated holes into plated holes. Some charge extra for non-plated holes.
If the screw is used to ground the board (for example, PC motherboards) then plated is the way to go- this one has the top, bottom and internal ground plane tied together with many small vias radially around the hole. There is no thermal relief on the vias. The vias ensure that even if the hole plating is damaged by the screw thread, the top and bottom pads are solidly connected to the ground plane.
Otherwise it doesn't matter much, though if you don't have any other unplated holes in the board, as Scott Seidman says, it can add cost to the board. Whether there is a pad or not (and the finish on the pad after assembly) may affect what kind of lockwasher or screw you choose to use on the PCB, since solder has a tendency to cold flow.
If the board is multilayer, there should be a large clearance between non-connected internal planes and (particularly) an unplated hole, because the thread can damage the internal surface (and sometimes people do things like drilling out holes that don't quite match the mating surface), and you don't want the screw shorting to (say) an internal power plane.
Best Answer
Digikey under "board supports" in link below and then in parametric search under "holding type" choose "edge" and "corner". There's about 10 or so suitable parts.
http://www.digikey.com/products/en/hardware-fasteners-accessories/board-supports/578
Also, if you dont mind ugly, just use long screws protruding up from your base plate, a nut to hold that screw rigidly, a second nut at the height of the bottom of board, the edge of the board pushed against the screw and then a third nut to hold the PC board down. Loctite to keep nuts from loosening. Ugly but will work.