connectoridentification
This is an 11-way connector pair from inside a standalone induction hob. It comprises a cable-mounted female part and a PCB mounted male part.
(Corrected due to sloppy original measuring – thanks @Passerby) Pitch is 2.5mm and pin length appears to be around 3.3mm. The female part is about 4mm wide and 8mm tall. Does anyone recognise this system?
I have seen similar on OEM GPS modules (inside car radios), medical lab instruments (blood drop analyser) and bank note acceptors (in vending machines).
They were all IDC type onto ribbon cable and most had a projecting plastic key pin on one end. I seem to remember either the plugs or sockets being red in colour often.
The ones I am thinking or are called Micro-MaTch and may be a variant though do not exhibit the zig-zag insulator characteristic.
That connector family is called the Mate-n-Lok series. They are great power connectors and have been around for years. They come in two general sizes, the Mini type and the standard or Universal series.
Here is a link to the Mouser catalogue page for the Mini.
Your two pin is hard to tell from the picture if it is the universal or the mini.
This is the one you are probably after:
Best Answer
Without precise measurements it's a little hard to tell, but I am pretty sure that its a JST XH series connector. A datasheet for these connectors can be found here.
The OP has since tested and confirmed this to be the correct part.