i2cmultiplexer
I'm looking over the schematics and PCB layout of the Adafruit TCA9548A I2C Multiplexer breakout board. I've attached the schematic below.
I cannot figure out why there are 10k resistors on the A2,A1,A0 addressing lines. Do these serve just as current-limiting resistors?
1) What happens when the I2C pullups are omitted?
There will be no communication on the I2C bus. At all. The MCU will not be able to generate the I2C start condition. The MCU will not be able to transmit the I2C address.
Wondering why it worked for 3 months? Read on.
2) The lack of pullups is likely to damage any of those two ICs in my board?
Probably not. In this particular case (MCU, RTC, nothing else), definitely not.
3) Why was the MCU able to communicate with the I2C slave device in the first place? I2C requires pull-up resistors. But they weren't included in the schematic.
Probably, you have internal pull-ups enabled on the ATmega. From what I've read1, ATmega have 20kΩ internal pull-ups, which can be enabled or disabled from the firmware. 20kΩ is way too weak for the I2C pull-up. But if the bus has a low capacitance (physically small) and communication is slow enough, then 20kΩ can still make the bus work. However, this is not a good reliable design, compared to using discrete pull-up resistors.
1Not an ATmega guy myself.
update: In response I2C waveforms, which were added to the O.P.
The waveforms in the O.P. have a very long rise time constant. Here's what I2C waveforms usually look like
PIC18F4550, Vcc=+5V, 2.2kΩ pull ups. Waveform shows SCL. The rise time on SDA is about the same. The physical size of the bus is moderate: 2 slave devices, PCB length ≈100mm.
Look closer...
There is only a single pair of pull-up resistors for each bus. Your diagram shows four separate I2C buses. The multiplexer and the repeater isolates the segments.
Thus, since you only have one bus, you only need two resistors: One for SCL and one for SDA.
Best Answer
They are just simple pull-down resistors, used to set the default value of the device address.
You can buy multiple of these boards, hook them up to the same bus and give them different addresses by pulling the lines high (note the solder pads on back side of the board).
10K value is a standard pull-up/pull-down resistor value, but anything between 5K and 100K would work just as well.