Electronic – Toaster Oven Reflow Thermocouple Grounding

It sounds like you're describing a ground loop, also an obnoxious problem in audio applications.

Even though your computer and roaster are presumably grounded, "ground" is not perfect. There are all sorts of high impedance paths between various ground points, and all sorts of effects, from mechanical triboelectric to electrochemical to stay fields from other conductors will cause small, subtle variations in the voltage. In short, it's total chaos, so you have to deal with it.

In a coffee roaster I assume you have motors which are relatively noisy, and there might be an actual (very small) electrical current flowing out a vent, as all the rubbing and heat is bound to create charged particles.

Using the relay to disconnect the neutral line doesn't really sound like you know what you're doing. You're exactly wrong in the safety department. In a perfect world, it's the hot that you want to switch. With only neutral switched, the heating coil is always energized, waiting to shock you.

Additionally, relying on a polarized electrical cord to try to make sure it's the hot you're switching has its own problems. You're better off using a double pole relay to fully disconnect the toaster from the electrical supply. Use a relay that is designed specifically to switch both legs of a power supply.

Also don't need to heat-shrink, glue, or electrical tape the wires, that's overkill and amateur hour. Hiding things in an attempt to increase safety is a sure way to decrease safety.

Use the project box, and mount your circuitry (including relay) on perf board. Simply solder the relay inline on the hot wire. Keep your low voltage relay control wiring (and arduino circuitry) physically separate from the relay and line voltage power wires. Do not let low voltage and high voltage come near each other, except at the relay, and even then, those come from different directions. Physically secure the power wires so they can't accidentally be pulled out. Be neat.

Your heating coils should be shielded from your pcb by a heat spreader, and your thermocouple should be next to the pcb, and not be touching anything. It's the air that heats up the pcb, and the air that heats up the thermocouple. You trying to bake the pcb, not broil it.

IMPORTANT SAFETY NOTE:
The electrical power that comes out of your outlets is extremely dangerous. It's not the fun-times easygoing stuff of 15 volts and below. It will surprise you, and given the opportunity, it will kill you.

From your question, you really don't seem to know what you're doing. I'm not trying to insult you, I just don't want you to die. Advice from the internet is not going to make this any safer. Sit down with someone in the real world who has worked PROFESSIONALLY with household electrical circuits and have them look over what you are doing.

Please be safe.