Is it possible to terminate one end of a CAN bus using Standard termination (single 120 ohm resistor across CANH and CANL) and the other end using Split termination (two 60 ohm in series with a capacitor between their joint and ground)?
Electronic – Using different termination types on CAN bus
buscansplittermination
Related Topic
- Electronic – arduino – Basic CAN-BUS circuit – what does this section do
- Electronic – Proper CAN bus termination
- Electronic – Terminator in Raspberry Pi CAN-shield
- Electronic – Common mode choke parameters CAN circuitry – split termination concept
- Electronic – CAN bus split termination impedance – no 60 ohm resistors
- Electronic – How does a CAN transceiver work
- Electronic – Automatic CAN bus termination
Best Answer
Yes. Split termination is an enhancement on simple termination. It should appear identical to a properly balanced differential signal.