dfmpcb
Found this slide and I didn't understand the last statement.
All fiducials should have same image one layer down
Are fiducials not top/bottom layer registration targets during assembly ?
Are/Can fiducials used during manufacturing to align layers prior to lamenting them ?
Blind and buried vias add a lot to the cost of a multi-layer board, and are only used on high-density, high-performance systems. The increase in cost is because the layers have to be drilled separately, assembled, and then the holes are plated. Blind vias are sometimes back-drilled (the unwanted plating is removed with a slightly larger drill from the back) which reduces the cost, as the layers are stacked before drilling.
Yes, one of the reasons for using 2-layer PCBs is to avoid the jump wires. On a complex board there would be lots of them in all directions. Your layout doesn't need the second layer, though; it's still simple enough to be routed on a single layer without wire bridges. If you get stuck you may have to move some components to another position, but it can be done.
I would suggest to try it instead of going the easy way of the 2-layer board. It's about practice. If you don't succeed in doing this on a single layer, you'll never be able to do a more complex board on a 2-layer PCB either.
A professionally made multilayer PCB will have copper-plated vias to connect the top trace with the bottom trace. If you plan to make the PCB yourself you won't have the through-metallization, but since you only use PTH parts you can solve that by soldering the wires on both sides of the board. For some components the wire may not be reachable on the component side. Just make sure there's no trace to the hole on that side then. If you would need vias apart from the components' mounting holes you can solder a thin wire on both sides of the hole.
2-layer PCBs will often use both layers for routing, and even component placement. On densely populated boards this may not leave much room for copper planes, like for ground or Vcc. If these are really required designers often will go to a 4-layer board. A ground plane not only helps in the design of HF designs, but ground is often the net with the most connections, so it takes a lot of routing away from the outer layers as well.
Today most PCBs use SMT technology, and SMDs will often be placed on both sides of the board. First the components on one side are fixed with glue dots, then the board is flipped and the parts on the other side are placed. The glue is needed to avoid the components falling of when the board is turned upside down. Some glue dot machines can place up to 50000 glue dots per hour, that's 14 per second!
Best Answer
Fiducials are registered using vision technology. Having the same image on the next layer into the board makes it clearer to a wider range of cameras.