This clamp is being used on a piece of equipment that is a few years old. I am trying to identify the type of clamp this is. If you the reader cannot identify it, leave a comment with something similar that will not damage thin wire when clamped.
Electronic – What kind of clamp is this
identification
Related Solutions
It is a thermostat as Dave Tweed and Kaz noticed.
I got a similar one and it has the temerature written on it:
For a single large planar backlight with very even lighting, the backlight technology of choice is the electroluminescent sheet or EL sheet / EL panel.
EL panels come in a variety of colors depending on the material used, and in a variety of sizes. Also, they can typically be cut to a desired size. For instance, see these EL panels from this eBay listing:
The lighting is very even across the panel. There is some color and intensity variation visible with change of EL excitation frequency, but with a good inverter design, that is rarely of concern.
LED backlights can be made even and smooth, but at the cost of an added diffusion layer, that loses some of the light intensity.
The second display in the question is most likely equipped with a sidelit LED backlight, going by the intensity pattern, 3 LEDs at the top.(Invalid hypothesis, OP's image editing gave a misleading impression)CCFL is commonly used for small or narrow displays, i.e. edge layout, or sometimes for large displays as well (some TVs for instance), but at the cost of a laser etched prism matrix sheet (or sometimes merely a diffusion sheet), again leading to some light loss.
Many common laptop displays use edge lighting with CCFL tubes. For instance, with my Lenovo laptop, I can actually see the bright sliver of edge lighting generated by a CCFL tube on each side of the display, if I flex the screen a bit. The light suffers a small amount of fall-off as one moves away from the edge, but that may not be evident to the naked eye: I can only spot it if I have a solid light color edge to edge on the display.
Best Answer
Ok, they look like the Kelvin clips on my cheap pair, which look identical to this one.
Please note the insulated hinge found on both.
Here is a set of clips from Amazon and one from Ebay.
If so then you need to replace it with another Kelvin clip, like one of the following:
Found at Amazon
Found at Ebay
AST Labs
That is just a small selection.