Electronic – Why is the Litz Wire twisted

The problem with the skin effect is that it forces the electrical current to flow near the surface of the wire. At high currents this can be an issue because, basically, the entire wire is not utilized resulting in higher cable losses and less efficiency.

The skin effect works like this (in a very dumbed down way): Current flowing in a wire will create a magnetic field, this magnetic field interacts with the current flowing. The net effect is that the current wants to "leave the wire" but can't because it's insulated. So instead the current bunches up at the edges of the wire and not in the middle.

Now, imagine that you have stranded wire, but not Litz wire. The skin effect will make the current want to leave the individual wire strand, and since there is a conductive path (another strand) the current WILL leave the strand. The end result is that a stranded wire is no better than solid wire when it comes to the skin effect.

Litz wire is like stranded wire but with the individual strands insulated from each other. So when the skin effect causes the current to want to leave the strand, it can't. Litz wire goes another step, however, by carefully arranging the strands in various ways to further even out the effects of the skin effect and other strange electro-magnetic effects. None of this would be possible with non-insulated strands.

Audio inputs are normally AC coupled (there is usually a series capacitor to block any DC component in the input). Typically this means you won't see much below about 20 Hz and you certainly won't be able to measure DC or slowly varying signals.

As for sensitivity, typical "live level" inputs expect a signal of 775 mV RMS which corresponds to 0 dBV. Microphone inputs are usually more sensitive than this, but there is no "standard" sensitivity and the input hardware often has some kind of controllable gain stage prior to the A-D converter.