So I got some HSR412s and connected them to my Christmas lights in a serial circuit. It worked great and as expected except for one caveat…. It was getting really hot. I realized I was putting double the rated current in and decided to go with a parallel circuit which could take more current.
I hooked up the wires like the picture said and when I plugged in the lights, they turned on, which is not what they should do when connected to these relays. I also tested to see if a parallel connection would turn the relay into the nominally open type, but that also was incorrect. I had my 6 and 4 pins connected to positive power in a Y split and had my 5 connected to the lights. I may have a misunderstanding of how a parallel circuit works but have no idea where I went wrong, and why the relays aren't working under my wiring. The datasheet is here.
Best Answer
The parallel configuration can take more current, but look closely and see that it is only applicable to DC. By "christmas lights", I expect you mean something intended to be plugged into normal house power, which would be AC.
A MOSFET can be a switch when used in forward mode (drain to source positive for N channel). However, these devices have a diode from source to drain as a byproduct of their construction. The series case puts the two diodes back to back, so one FET is always blocking when off. The parallel configuration is only for one power polarity since the diodes will conduct in the other direction. AC power will be on for at least every other half cycle with the parallel configuration.