OK, let me 1st give you some background information.
I need to generate 40,000 lux of light in an indoor environment (in a area of around 5 feet by 3 feet) and I need the ability to turn the light on/off in 1 minute intervals for around 10 hours straight (about 600 off/on events in the span of 10 hours).
So far I've come up with two options. I can buy several high-watt compact fluorescent lamp (bulbs) and use a timer than can turn it off/on in 1 minute increments. I already have a timer than can do this so I have no problem with this point. However, I would need around 30-50 105 watt bulbs to generate this kind of light. The benefit of using CFL is that it can be turned on/off in a relatively short time (many are instant on but even if not it won't take more than 20-30 seconds). However, I'd need a ton of such bulbs.
My other option is to use a METAL HALIDE BULB. 1 such bulb can easily generate 40,000 lumens using only 400 watt (compared to 1500+ watt for the CFL bulbs). However, the main issue with these are that it takes anywhere between 3-5 minutes (sometimes more) for the bulb to reach full luminosity – and I need it to reach full luminosity within a minute or less (instant is ideal).
Furthermore (as Wesley Lee pointed out) I would need to wait several minutes to turn it back on after turning it off (I accidentally omitted this from my OP).
One solution I thought of was keeping the bulb on indefinitely and placing it in a box. The box will then open and close in 1 minute increments. Thereby allowing the light to illuminate the area for 1 minute and then when the box is closed no light will be emitted.
My question is how to make an apparatus that opens and closes in 1 minute increments? Or is there another simpler solution to my problem?
The solution needs to be automated (not manual).
Thanks
More later ...
Best Answer
You could build a mechanical shutter operated by a servo motor and controlled by a microcontroller easily enough, but there is another issue.
Your 400W of input power is being turned into light and heat. I don't know what the efficiency of your proposed bulb is, but even if it was as high as 25% (dubious) you'd still need to dispose safely of 300W of heat continuously. When the shutter obstructs the light the waste heat will probably ramp up to almost the full 400W because most of the 40k lumens are going to be converted back into heat.
Have you looked for high power LED's (or LED arrays) that can generate the kind of light intensity you need? LED's can usually be switched on and off pretty much as required, and they're also generally more efficient than other light sources.