Unable to read data from I2C

I am interfacing DS1307 with PIC32MX795F512L using peripheral library. I am able to send data but not able to receive it.

Code:

#include <plib.h>

#define BAUDRATE    115200
#define Fsck        100000
#define BRG         ((FPB/2/Fsck)-2)

#define FCY     66000000L
#define FPB     (FCY/2)

#pragma config POSCMOD=HS, FNOSC=PRIPLL 
#pragma config FPLLIDIV=DIV_3, FPLLMUL=MUL_18, FPLLODIV=DIV_1 
#pragma config FPBDIV=DIV_2, FWDTEN=OFF  
#pragma config FSOSCEN = OFF 
#pragma config ICESEL = ICS_PGx2

int main(int argc, char** argv)
{

 OpenUART1( UART_EN | UART_NO_PAR_8BIT | UART_1STOPBIT  , UART_RX_ENABLE | UART_TX_ENABLE, (FPB/16/BAUDRATE)-1 );
putsUART1("START\n");
int res;

OpenI2C2(I2C_EN, 163); // I2C channel Configuration

StartI2C2();

IdleI2C2();
MasterWriteI2C2(0xD0); 
Nop();
MasterWriteI2C2(0x01); 
Nop();
MasterWriteI2C2(0b00010011); 
Nop();
StopI2C2();

IdleI2C2(); 
StartI2C2();
IdleI2C2(); 
MasterWriteI2C2(0xD0);

Nop();
MasterWriteI2C2(0x01);
Nop();
StopI2C2();

RestartI2C2();
IdleI2C2();
MasterWriteI2C2(0xD1);
Nop();
MasterWriteI2C2(0x01);
IdleI2C2();
res = MasterReadI2C2();
Nop();
NotAckI2C2();
Nop();
StopI2C2();

 //converting to ASCII
unsigned char x,y,p1,p2;
x = res & 0x0F;
p1 = x | 0x30;
y = res & 0xF0;
y = y >> 4;
p2 = y | 0x30;

char value1[5] ;
char value2[5] ;
sprintf(value1,"%d",p1);
sprintf(value2,"%d",p2);
putsUART1(value1);
putsUART1(value2);
putsUART1("\n");


while(1)
{

}

return (EXIT_SUCCESS);
}

UART is working fine and there is no collision because the function MasterWriteI2C2() returns -1 if there is collision and returns 0 if there is no collision and data transmission is successful & I have received 0, that means data is being transmitted but I don't know why its not able to read back data. Please help.

EDIT:

I resolved the problem which I was facing and now I2C is working as I can see the received value in I2CRCV register is same which I am sending. But I need to send the value to UART for which I think I need to convert them to ASCII but after converting the values will change. Lets say I have set 13 value in seconds register then its value will change during conversion, then how can I set RTC value. I need to make a logic so that I can set the RTC value from UART.
Please help.!