Would a LCA110 DIP-6 solid state relay work for switching 330v DC? I cannot find information on the datasheet of whether or not this is suitable for switching 330 volts DC. I am using it to switch 5 80uf 330v capacitors into a coil for a coilgun, using an Arduino.
Using a LCA110 DIP-6 Solid State Relay to switch 330v DC
arduinocapacitorcoilrelaysolid-state-relay
Related Topic
- Electronic – arduino – Switching frequency of a solid state relay
- How to use a solid state relay in a dip package to drive a 24 vac relay
- Using Arduino relay board outside its intended voltage
- Electronic – arduino – Create SPDT relay from two SPST solid state relays
- Electrical – Possibility of using 5A 5-220VDC Solid State Relay for switching 120VAC String Lights
- Electronic – Heat dissipation in a DIP Solid State Relay
- Electronic – Solid State Relay Voltage When Off
Best Answer
It's right there at the top of the DS: -
However, If you think it's going to survive your application I'd think again. Here's the hint - look at the load current.