Here my problem. I need to install and configure 2 units Brocade ICX6610 as core switch. Im already done with setting up new vlan on Fortigate and some vlan dhcp pool in 6610. My problem is when i want to config ip address for vlan, there are no 'router-interface' command under vlan configuration.
LPK-ICX6610-01(config)#sh running-config
Current configuration:
!
ver 08.0.10gT7f1
!
stack unit 1
module 1 icx6610-24-port-management-module
module 2 icx6610-qsfp-10-port-160g-module
module 3 icx6610-8-port-10g-dual-mode-module
stack-trunk 1/2/1 to 1/2/2
stack-trunk 1/2/6 to 1/2/7
stack-port 1/2/1 1/2/6
stack enable
!
!
!
!
vlan 1 name DEFAULT-VLAN by port
!
vlan 10 name LANUSER_GF by port
tagged ethe 1/1/3
!
vlan 20 name LANUSER_1F by port
!
vlan 100 name WLAN by port
tagged ethe 1/1/23 to 1/1/24
untagged ethe 1/1/12
!
!
!
!
hostname LPK-ICX6610-01
no ip dhcp-client enable
ip dhcp-server enable
!
ip dhcp-server pool vlan_100
dhcp-default-router 192.168.100.254
dns-server 1.9.1.9 8.8.8.8
excluded-address 192.168.100.1 192.168.100.10
lease 0 12 0
network 192.168.100.0 255.255.255.0
deploy
!
!
!
!
!
!
!
!
!
!
!
end
LPK-ICX6610-01(config)#sh version
Copyright (c) 1996-2014 Brocade Communications Systems, Inc. All rights
reserved.
UNIT 1: compiled on Dec 17 2014 at 18:25:28 labeled as FCXS08010g
(7280225 bytes) from Primary /FCXS08010g.bin
SW: Version 08.0.10gT7f1
Boot-Monitor Image size = 370695, Version:10.1.00T7f5 (grz10100)
HW: Stackable ICX6610-24*
--------------------------------------------------
LPK-ICX6610-01(config)#
LPK-ICX6610-01(config)#vlan 100
LPK-ICX6610-01(config-vlan-100)#router-interface ve 100
Invalid input -> router-interface ve 100
Type ? for a list
LPK-ICX6610-01(config-vlan-100)#
Best Answer
You're running L2 firmware (FCXS); reflash with L3 firmware (FCXR) and try again.