For the ASR 1K, Advanced Enterprise Services is needed to support "legacy protocols" (IBM, IPX, etc.), but for IP protocols, including IPv6 and BGP, Advanced IP Services should be adequate. See the following links for more information.
This one has flummoxed me in the past. The commands you're looking for relate to turning on the 8-Bit character set.
Now, this may still not allow the cellular modem to send the characters via SMS (I do not have a card to test this with), however this is the only command that I know of that may help you out.
Per the Configuring Operating Characteristics for Terminals guide from Cisco (specifically the section on Specifying an International Character Display):
The classic U.S. ASCII character set is limited to 7 bits (128
characters), which adequately represents most displays in the U.S.
Most defaults on the modem router work best on a 7-bit path. However,
international character sets and special symbol display can require an
8-bit wide path and other handling.
You can use a 7-bit character set (such as ASCII), or you can enable a
full 8-bit international character set (such as ISO 8859). This allows
special graphical and international characters for use in banners and
prompts, and adds special characters such as software flow control.
The commands to enable 8 bit character set are:
default-value special-character-bits 8
default-value exec-character-bits 8
To test, I tried to type æ into my lab router with the following results:
R-VOIPLAB#
R-VOIPLAB#>
Since I have the default 7-bit character lengths turned on, it interpreted the æ as angle brackets.
Now, I turned on 8 bit character sets and logged out of my session and back in (the logout is necessary to begin using the new terminal settings we just configured):
R-VOIPLAB#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R-VOIPLAB(config)#default-value exec-character-bits 8
R-VOIPLAB(config)#default-value special-character-bits 8
R-VOIPLAB(config)#exit
R-VOIPLAB#exit
After logging back in:
R-VOIPLAB#
R-VOIPLAB#æ
R-VOIPLAB#æ, ø, å
Notes:
This testing was done with the following configuration, so your milage might vary with a different terminal emulator, different router, etc:
- Test computer: Mac OSX 10.9.2
- Terminal program: SecureCRT for Mac, Version 7.2.0
- Terminal emulation type: VT100
- Connection type: SSH
- Router: 2821
- IOS: 15.1(4)M6
Best Answer
The thresholds will differ depending on the IOS, platform, and component in question. The
show environment table
command will display the temperature thresholds. When a threshold is crossed, a SNMP trap will be sent, if the router is configured to do so.Here is a sample output:
More information on the
environment
command can be found in the Cisco IOS Configuration Fundamentals Command Reference .