I'm trying to set up chassis cluster on Juniper SRX300 (Junos 15.1X49-D45).
And I wasn't able to find any documentation on this matter.
I was able to run the command:
set chassis cluster cluster-id 0 node 0[1] reboot
on both nodes, but after the reboot cluster is not enabled:
root> show chassis cluster status
error: Chassis cluster is not enabled.
Is the anything else I should do?
Is there any special license required?
Best Answer
You can find full documentation here.
You're on the right track, but cluster-id should be greater than 0. From the documentation:
Keep in mind that you need to connect the two SRX300 devices on port ge-0/0/1 (for the control link). In the factory default configuration, this interface is already configured and part of a security zone; you need to remove all configuration relating to this interface before the chassis cluster will form.