which type information can be seen by executing keywords "GET" and "SHOW" with combination other keywords at Fortigate firewall cli in general way. Can anyone differentiate the information print by using these keywords.
Fortigate Firewall – CLI Query for Show and Get Commands
fortigatefortinet
Related Topic
- SIP Trunking – Is a Dedicated SBC Required for SIP Trunking Through FortiGate 200B Firewall?
- GRE over IPsec between Juniper SRX100 and Fortigate 100D
- Fortigate 50e – Setting Up Conditional Forwarding
- Tcp – Dropping packets between router and firewall without firewall rule
- Routing – Fortigate and ipv6 routing
Best Answer
As far as I can remember show is used to check parameters and options as they are set in configuration, while get is used to check runtime values. Let say you have configured an interface for autonegotiation. You can see this with a show command. When the interface comes up it negotiates 100/full. You can check this with a get command