IPv6 – Troubleshooting First IPv6 Ping Failure

Answers to your questions:

1. No, just because device supports IPv6 it doesn't mean it support IPv4<>IPv6 transition mechanisms - they're not part of IPv6 protocol specification. So, it may support translating traffic from IPv4 to IPv6 and vice versa but it needs to support mechansism like NAT64.

2. Nodes communicate with the protocol of their choice, depending on the higher layer calls. If your browser points to a name, and the name resolves to IPv4 only, IPv4 will be called in to service it. If it resolves to both IPv6 and IPv4, IPv6 should take precedence, but a lot was done in recent years to make both calls simultaneusly and check which one is faster.

3. You need to have node that is dual-stacked, so supports both IPv4 and IPv6 or have support of translating between protocols somewhere along the way. If your router supports it - fine, if your ISP supports it - it's also fine.

4. You should see IPv6 as it should take precedence. If not, your IPv6 connectivity, at least to this specific site is broken. If you can use only IPv6 (you are not dual stacked) you can only reach around 4-5k prefixes around the internet, which is very small percent (out of 500k for IPv4). Normally, hosts are dual-stacked however, so you should be fine - using IPv6 for IPv6-enabled services, and IPv4 for all the rest.

5. That depends on the type of the service your ISP provides. You may have private IPv4 assigned to your internet interface, and it gets translated somewhere at the ISP edge. You may have public IPv4.

6. For SSL/TLS you're using names, not IPs directly. You should be fine.

7. Yes, while there are still works to provide NAT services for IPv6, general idea about IPv6 was to stop doing NAT, and provide global connectivity. It means that with IPv6 assignment, your entire internal network may be directly reachable from other parts of the internet, if you're using IPv6 addresses from the Global Unicast space. For IPv6 you can use other types, like for example Link Local only, which would provide internal connectivity, but block ability to access from remote locations. Generally, you should filter the traffic at the edge of your network if you don't want the internet to access your resources/nodes.

8. Unfortunately, I don't understand the question. Cloud services are usually OK with IPv6, Amazon at least is.

9. Start from here: http://test-ipv6.com/

A non-router shouldn't send RAs, but they can. If you say the lifetime to zero devices won't use it as a default gateway. The problem is advertising a single prefix by all your devices on all networks. Don't assume that users will only have one subnet and that users won't want to connect to your devices across different subnets.

The best solution is to use multicast name resolution like mDNS and LLMNR. Take a look at https://serverfault.com/questions/352632/name-resolution-in-an-ipv6-network-without-a-dns-server.

Another option is to provide a simple IPv6 "dummy router" to your customers that advertises a prefix, where each router advertises a different ULA prefix that is printed on the outside. It can advertise a default gateway lifetime of 0 so it doesn't become a default gateway. Customers that have IPv6 already can use their own prefix, and customers without IPv6 can use/buy/etc your dummy router and use its unique ULA prefix.