Accessing Supermicro IPMI via SSH

Jiri's on the right track with the three options (Dedicated, Share, Failover) for the IPMI interface. The short answer is that yes, you can use LAN1 instead of the dedicated IPMI port, and it generally works that way with the default BIOS settings. It's not possible to run the IPMI on the LAN2 interface.

Here's a more detailed description of the three options:

• Dedicated: Always use the dedicated IPMI interface. This is the option you want if you're trying to have the simplest setup, at the expense of additional cabling.

• Shared: Always use the LAN1 interface. This is the option you want if you're trying to reduce your cabling to each server, and understand the tradeoffs. Under the covers, there's a virtual switch in hardware that's splitting out traffic to the IPMI card from traffic to the rest of the system; the IPMI card has a separate MAC address to differentiate the traffic. On modern Supermicro boards, you can also set the IPMI traffic to run on a different VLAN from the rest of the system, so you can tag the IPMI traffic. There are some definite security implication to this design; it's not difficult for the main system to access the IPMI network, if you were trying to keep them separated. A failure of the LAN1 interface often means that you lose primary and out-of-band connectivity at the same time.

• Failover (factory default): On boot, detect if the dedicated IPMI interface is connected. If so, use the dedicated interface, otherwise fall back to the shared LAN1. I've never found a good use for this option. As best I can tell, this setup is fundamentally flawed - I haven't tested it extensively, but I've heard reports it'll fail to detect the dedicated interface in many circumstances because the upstream switch isn't passing traffic - for example, after a power outage if the switch and system come up simultaneously, or if the switch is still blocking during the spanning tree detection. Combine this with the fact that the check only happens at boot, and it's just generally hard to control what interface you end up using.

From where are you trying to ping the card - if it is from the host itself, different rules apply in case the NIC has gone to Shared mode..

May I suggest you check Supermicro's FAQ database, there is a lot on IPMI card behaviour in there...