Well, seeing as though I pulled my hair out solving this, let me answer my question and save someone else the trouble of hair pulling :)
Solution:
After playing around, plenty of Googling and repartitioning etc... I came to a setup that works like a charm.
There is probably a quicker way to do this but I am not going to over complicate this answer
I did a standard install with the partitions like this (I have a 500g hard drive) :
/boot 100mb
/swap 4gb
/ 40gb
The balance of the disk space is to be left as unpartitioned space.
Then, I created a primary partition called /dev/sda4 by following these steps:
~: fdisk /dev/sda
~: (fdisk shell) p4 (for primary partition # 4)
~: (fdisk shell) t (hit t and enter to edit the partition type)
~: (fdisk shell) 08e (Linux LVM)
Reboot the server so that the new partitions can take effect.
Now create logical volumes by:
~: pvcreate /dev/sda4
~: vgcreate xenvg -s 4M /dev/sda4 # (xenvg is the name of my virtual group, you can rename it)
~: lvcreate -L400G -n xenroot xenvg # (xenroot is going to be my drbd resource and root partition for my DomU)
~: lvcreate -L4G -n xenswap xenvg # (xenswap is my swap file for my DomU)
Now that you have the correct partitioning you can go ahead and install DRBD with the following config file directives (drbd.conf)
Just displaying the 2 important directives here...
{
device /dev/drbd0;
disk /dev/xenvg/xenroot;
}
Your XEN VM config file needs to look like this (again, just the important one)
{
disk = [ "drbd:xenvm,xvda,w","phy:xenvg/xenswap,xvdb,w" ]
}
I hope this helps someone out there...
Best Answer
We use a script in-house for calculating
DRBD
meta sizes for LVM partitions.This is a script that just takes the block device as an argument.
Eg.
metacalc.sh /dev/vg1/root
This is the contents of the script ... (it also happens to give the command to resize the file system on the
DRBD
disk too).metacalc.sh
The only prerequisite is that
bc
is installedyum install bc
apt-get install bc