I have two 3750-X switches operating in a stack. The SDM template is set to desktop routing, as we need a lot of next-hop unicast routes.
The tcam usage is not looking quite right…every value is maxed out. Has anyone seen this before (or have any explanation to it), or should I open a TAC case right away?
CAM Utilization for ASIC# 0 Max Used
Masks/Values Masks/values
Unicast mac addresses: 3292/3292 627/627
IPv4 IGMP groups + multicast routes: 1120/1120 1/1
IPv4 unicast directly-connected routes: 3072/3072 92/92
IPv4 unicast indirectly-connected routes: 8144/8144 3730/3730
IPv4 policy based routing aces: 498/498 13/13
IPv4 qos aces: 474/474 21/21
IPv4 security aces: 972/972 33/33
Edit:
Here is an example from Cisco, wich looks quite different:
http://www.cisco.com/en/US/products/hw/switches/ps5023/products_tech_note09186a00807213f5.shtml#SDM
Edit2:
I might want to add the reason why I'm investigating this: We're experiencing very random latency when we ping this switch, no matter what VRF or VLAN we use. The CPU utilization looks a bit weird as well:
6644646454444584445446554355447464554555554444464645444445457455556545
6907344850716408995114547934140092790235780624077383760641040825126164
100
90
80 *
70 ** * * * * * *
60 ** * * * * * ** * * ** *** * * * * *
50 ** ** *** * ******* **** ** * * ** ***** * ******* * * ***********
40 **********************************************************************
30 **********************************************************************
20 ######################################################################
10 ######################################################################
0....5....1....1....2....2....3....3....4....4....5....5....6....6....7.
0 5 0 5 0 5 0 5 0 5 0 5 0
CPU% per hour (last 72 hours)
Current usage:
CPU utilization for five seconds: 25%/1%; one minute: 24%; five minutes: 24%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
81 105562156 425102 248330 13.41% 11.52% 11.62% 0 Adjust Regions
75 38660112 6968319 5547 3.03% 2.94% 2.84% 0 RedEarth Tx Mana
74 24316130 11091855 2192 1.59% 1.59% 1.59% 0 RedEarth I2C dri
4 15330586 677415 22631 0.00% 1.14% 1.14% 0 Check heaps
Best Answer
You're not maxed out. The second set of numbers is the current utilization, and the first column is the max.
Edit 1: On page 17 of this link is a decent explanation of it.
Edit 2: For your underlying issue that you are noting, take a look at
show controller utilization
to get a good feel for the traffic you're seeing. Also, here's a decent guide from Cisco on troubleshooting high CPU usage in 3750s (linked here)