I have a cisco 7206 that terminates a bunch of pppoa sessions for dsl users. Today I noticed that if I tried to "show run" nothing happened. I mean that it doesn't show anything and just sends me right back to the command prompt. I decided I should probably try and back up the config and that is where I'm stuck. Any time I try to copy the running-config to tftp or to pcmcia card that I know is not full I get the following error:
%Error opening system:/running-config (Bad file number)
I get this error when I try to do anything with the running config. I've been googling around, but I haven't found any thing else that talks about this error. I've seen people say to erase the nvram and then try to "copy run start", but I don't want to erase the nvram until I can pull off a copy of the running-config. I would try to reboot it, but the startup-config that is on the nvram looks to be woefully out of date (good job me!).
Any ideas what might be wrong? or how I can get the running config off the router?
Best Answer
This sounds like there is something going on with your flash/memeory. can you dir system: ? can you copy the startup-config off to tftp (at least if the systems does go down hard you'll have somewhere to go from).
Also i would open a TAC case.