All I'm trying to do is copy the running-config from a Cisco Catalyst 2560 PoE 24, to a Catalyst 3560 PoE 48. This is f0/1 from the original switch:
interface FastEthernet0/1
switchport access vlan 40
switchport mode access
switchport voice vlan 98
srr-queue bandwidth share 10 10 60 20
priority-queue out
mls qos trust cos
auto qos trust <----------------------
no cdp enable
spanning-tree portfast
On the previous 2560 it was set to "auto qos voip trust" (the arrow); I get the following error when I import the running-config into the 3560:
AutoQoS Error: AutoQoS already configured
I turned off autoqos with a debug auto qos and a no mls qos globally, removed the auto qos trust then a auto qos voip trust
I received no warnings after entering the last command but on a show config, it's still not listing the voip trust. Any ideas where to look?
Thanks!
Best Answer
Its a bit hard to follow what has happened based on your description - but try "show auto qos interface fastethernet 0/1" and see what it tells you
You can find a good description of everything Auto QoS will configure and its expected behaviors @ http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/12-2_53_se/configuration/guide/3750xscg/swqos.html#wp1231112
You must be running IOS 15 - they changed the command to "auto qos trust" and removed the VOIP sub command. This change is described @ http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/15-2_1_e/configuration/guide/scg3750x/swqos.html#wp1739670
In short - you're fine; 'auto qos trust' is a proper substitution to 'auto qos voip trust'.