Cisco – Is there Muticast routing support on a Cisco 3750

If you want to direct or tag the traffic originating from the switch or router (will work on IPBASE) I'm guessing you already succeeded but if not.

conf t

access-list 1 any

route-map pbr permit 10

 match ip address 1

 set ip next-hop 3.3.3.3

exit

ip local policy route-map pbr

end

wr

Note that ip local policy is specified in global configuration, not under an interface. And you might want to have a more detailed ACL

This is only for traffic that originates from the device, not traffic that passes through it.

We operate a couple network implementations where third-party connections are linked up to a centralized Cisco backbone (i.e. multi-tenant setup). I can say I've seen a bunch of diverse (okay, ghetto) devices connected up to the Catalyst platform, and if there's one thing I've learned, it's that the Cisco platform is remarkably resilient to these kinds of things.

There is one achilles heel, though - A cheap hub in the right configuration can easily bring down an entire network with a broadcast storm, and it's not even the Cisco platform's fault. I discovered this in a production configuration, and the only real research I did was finding the closest trash can for that hub, but here's how it happened:

1. Connect hub to Cisco switch as normal, with uplink port
2. Connect a workstation to a hub port (in our case, running Windows XP OS, but shouldn't matter)
3. Connect two other ports together on the hub (either directly, with a single CAT5 or indirectly through another hub).

Everything runs smoothly until that workstation sends out a broadcast announcement. While the hub and the Cisco are smart enough to prevent a broadcast storm on other broadcast packets, the hub isn't smart enough to detect that two of its ports are connected to each other, and will use up almost 100% of its processing power to broadcast that packet in an infinite loop back and forth, as well as out all the other ports (i.e. the uplink to your Cisco).

If this is the case in your configuration, you will notice that across your network, all of the ports on that broadcast VLAN will go nuts, up until the hub can't sustain the capacity and drops the magical looping packet (could be a couple minutes depending on the competing traffic), and then all is back to normal.

In this situation SNMP won't help you since all the ports on that VLAN go crazy with traffic. However, Wireshark is your friend here, since it's easy to capture which IP (and sometimes machine name if it's a broadcast packet) caused the loop, and quickly locate the offending device.

May not be the exact case you're experiencing, but this one bit us hard and might give you some ideas to research with your situation.