Clearing Active Error Events In IBM IMM 2

Windows Server has a built in SNMP trap generator for the Windows Event Log/Viewer, which can send traps on the occurrence of arbitrary events.

Trap Form (OID)

These traps will conform to the Microsoft private enterprise MIB branch in the following form:

1.3.6.1.4.1.311.1.13.X.n.n.n.n.n.n.n.n.n... 

Each "n" is a decimal encoding of an ASCII character octet from the Event Log source name, and the X designates the number of characters to follow.

So, for example, a trap generated by source "Prefect" (as seen in Event Viewer) would appear as:

1.3.6.1.4.1.311.1.13.7.80.114.101.102.101.99.116 

Windows 2000 Server does not support this fully, and will generate traps of a slightly different format, but the procedure is otherwise identical. All newer versions of Windows server support this properly

Configuring Trap Sending

There are two built-in tools that you will use to set up trap generation.

evntwin: Create mapping of Event Log messages to SNMP traps evntcmd: Load mapping created by evntwin so that traps are generated

Run evntwin from a command prompt: this will spawn a GUI. Select "Custom" under Configuration type, and then "Edit." You will now see a list of all possible event sources. Under the source in which you are interested, select the particular event ID on which you wish to generate traps. Then, click "Add."

Now, you will see the actual OID of the trap, the specific ID, and an option to set a time-based threshold of event occurrences before the trap would be sent.

Repeat until you have created a mapping for each particular trap/event combination you care about. Then, click "Apply," highlight all of the mappings, and then "Export..." Save the file, and exit the application.

Now, again from the command line, run evntcmd, specifying the name of the file you just created:

evntcmd myeventfile.cnf

From this point forward, the events you specified will generate SNMP traps, which will be sent to all trap receiver destinations you have configured in your SNMP service settings. Process them as you would any normal SNMP trap.

Here is the list of ports you need to have open.

Edit: Do the normal network problem debugging. Can you ping the server? Does tcptraceroute to the appropriate port work OK? Can you telnet to the appropriate port?

If RC works over LAN but does not remotely it does look like a networking issue.