CX4/SFP+ -> Fiber adapters

10gigefiber

I'm putting together a proposal for a greenfield 10GigE network (including 10GigE uplinks to providers) while trying to be careful about budget.

One of the hardware configurations I'm evaluating that would be relatively inexpensive is a blade chassis with a 10GigE uplink module that gives me a set of 2 CX4 connectors + 1 SFP+ connector (there's no good way to substitute a fiber module in this configuration without exploding the budget).

While the SFP+ would be fine IF the datacenter supports SFP+ (which is still pretty new), CX4 obviously isn't going to work for uplinks to providers, and we'll need more than one 10GigE uplink.

HP offers CX4->Multi-Mode Fiber adapters for their ProCurve gear for less than $1000/each. This would be fine, but the problem is the CX4 adapters aren't coming out of HP/ProCurve gear. I can't seem to find non-ProCurve adapters.

So there are several inter-related questions here:

  1. Do the ProCurve adapters work with any CX4 connector?
  2. If not, are there "generic" adapters out there that do?
  3. Are there likewise any SFP+ -> MMF adapters available in case the provider doesn't support SFP+ yet?

Thanks.

Edit: Couple extra details:

  • The blade system is from SuperMicro, and their network modules are visible here: http://www.supermicro.com/servers/blade/networking/
  • I'm trying to avoid having to buy an external 10GigE switch to uplink the blades to.
  • We will eventually probably have to go 10GigE top to bottom (sticking Infiniband modules in the blades for use as 10GigE adapters) and switch to SuperMicro's 10GigE pass-through module with external 10GigE switches, but I want to put that off until the project is showing a return on investment.

Edit II: chris's answer set me straight on SFP+ (for unknown reasons, I'd confused it with 10GBASE-T in my mind). I'm still hoping for a pointer at CX4->MMF converters, however, since one or two 10GigE uplinks through SFP+ won't be enough long-term — I'm looking to eventually push close to 30gbps out per chassis.

Best Answer

I'm not sure I understand your question.

I just looked at the manual for the supermicro blade chassis and it supports two network modules, so you'd be able to have 4 cx4 and 2 sfp+ interfaces in your chassis; this ought to provide a reasonable level of redundancy.

If your provider is offering you 10gigE over multimode fiber, you could connect the supermicro switches to your provider directly using an SFP+ module such as this one.

SFP+ isn't an interconnect standard. It is a transceiver standard to allow a single device to optionally support any of the available interconnect standards in use (long haul or short haul optical, short distance digital interconnects, etc). 10GBASE-CX4‎, 10GBaseT, 10GBASE-SR, and so on -- these are interconnect standards and each end of a link needs to use the same standard, but it doesn't matter if one end is xenpak and the other is sfp+ or hardwired, or made out of cheese, so long as the media supports the proper interconnect standard.

So I'm not sure why you need anything else like a media converter.

Related Topic