Dell H700 Controller, BBU present but not charging…

I have a new Dell R710 with a H700+BBU controller that is not charging.
Last week when I was looking at performance stats (and trying to figure out why write policy had changed from write-back to write-through) I realized the BBU was not charged. The overall stats available through MegaCli appear to indicate the BBU is OK but it wont charge.
I kicked off a manual learn cycle, waited a couple days, reseated the BBU, and nothing seems to get the BBU to a charging or charged state.

Any help is much appreciated.

/opt/MegaRAID/MegaCli/MegaCli64 -AdpBbuCmd -GetBbuStatus -a0

BBU status for Adapter: 0

BatteryType: BBU
Voltage: 2960 mV
Current: 0 mA
Temperature: 27 C

BBU Firmware Status:

  Charging Status              : None
  Voltage                      : OK
  Temperature                  : OK
  Learn Cycle Requested        : No
  Learn Cycle Active           : No
  Learn Cycle Status           : OK
  Learn Cycle Timeout          : No
  I2c Errors Detected          : No
  Battery Pack Missing         : No
  Battery Replacement required : No
  Remaining Capacity Low       : Yes
  Periodic Learn Required      : No
  Transparent Learn            : No

Battery state: 

GasGuageStatus:
  Fully Discharged        : Yes
  Fully Charged           : No
  Discharging             : Yes
  Initialized             : Yes
  Remaining Time Alarm    : Yes
  Remaining Capacity Alarm: Yes
  Discharge Terminated    : No
  Over Temperature        : No
  Charging Terminated     : No
  Over Charged            : No

Relative State of Charge: 0 %
Charger Status: Unknown
Remaining Capacity: 0 mAh
Full Charge Capacity: 1700 mAh
isSOHGood: Yes

Exit Code: 0x00